THE OFFICIAL WEBSITE OF THE HAMMER’S SLAMMERS THE CRUCIBLE RULES SYSTEM HANDBOOK Click pictures to enlarge Return to Hammers Slammers Galleries page Super detailed 6mm Slammers - by Ralph DeLucia The Splinter Shield was made from Scale Scenics Micro-Mesh. Cut to size and shape of the shield on the Old Crow insert. It's about 12mm long and 6mm wide at the rear and narrows down to the front to about 5mm. When cut, I glued it on top of the supports - again I used the Old Crow insert as a guide. I next decided to mount an optional Anti-mine Launcher on the front hull and a long range antenna on the rear.  I wanted to put these items on as this will be the only one I "super detail" because, as I said, it was an extra hull ... And it will be the Major's! I added an Anti-Mine Launcher and long range antenna -  again using StripStyrene. To make the Anti-Mine Launcher, I cut a 2-3 mm square rod, approximately 5mm long to fit part way across the front skirt, and then bevelled the front edge. Then to make the long range antenna I cut a 1-2mm round rod about 4-5 mm long and glued it between the right rear support strut and rear access door. So, with the M9 finished, I then I decided to make a modified M2 Blower based on the Slammers story Rolling Hot. Next page. The M9 with the anti-mine box and long range arial added The M9 finished and painted The M9 finished and painted The M2 and the M9 finished and painted This Slammers M9A7 Combat Car in dazzle pattern has a mine box on the front